Satellite Finder ANTSF1N
Satellite Finder ANTSF1N
Click the image for a larger view.
How To Aim Satellite Dish
•First connect the satellite finder between the LNB and the satellite receiver. •Turn on the receiver. You'll hear a beep and see the backlight light up. •Point the dish to the approximate azimuth direction (left or right). •Adjust the dish elevation angle (up or down). •Adjust the LNBF tilt angle (if adjustable).
•Adjust the sensitivity of the satellite finder by turning the knob until the needle is near 5 (mid point). •Move the dish slowly in the azimuth direction. When the signal strength meter reaches its highest point, stop moving the dish. If the needle reaches the maximum reading, lower the sensitivity until the needle is back to 5. •Adjust the dish again until the needle won't go higher. •Now adjust the satellite dish elevation angle and follow the same steps as above (adjust sensitivity if necessary).
Features
- pocket size and light weight
- high sensitivity for for easy and precise satellite dish alignment
- 22Khz detection LED
- H/V LED, indicates when the LNB is switching polarization
- backlight for easy viewing
- audio tone function
Specifications
- frequency range: 900 to 2400MHz
- input level: -52 to 60dB
- sensitivity: 7µV at 55dB
- power supply: 13 to 18Vdc (from receiver)
- dimensions: 3.23" x 2.48" x 1.26" (8.2cm x 6.3cm x 3.2cm)
- factory assembled and ready to use
Price
Quantity 1 to 9 $ 9.95
Quantity 10 or More $ 8.89